Description

RODUCT DESCRIPTION Technology Poly sulphide Chemical type Moisture curing Components Two component – requires mixingCure Room temperature vulcanizing (RTV) Application Sealing Anabond Tuffseald 2G is a two component polysulphide sealant conforming to BS 4254 : 1983 used for sealing expansion joint sealant movement is anticipated in concrete construction and for joints between diverse construction materials like glass, aluminium, steel & glazing. It has been used in internal and external wall cladding / sealing of joints in water retaining structures such as reservoirs, dams, tanks etc. It is also used for sealing of expansion joints where there is vehicular traffic (e.g. airports and bridges) or pedestrian traffic.After mixing Resin and Hardener, the polymerization is initiated at room temperature, which proceed further until it is cured. It has superior joint movement accommodation with strong adhesion to most building material.It is chemically resistant to petrol,diesel fuel & kerosene. Resin Appearance Smooth pasteColour Specific gravity at 300C, ATM* R004 (JIS* K6820) 1.60 Flash Point Anabond® Tuffseald 2G Japanese Industrial standard, ASTM – American Society for testing and materials, requires mixing vulcanizing is a two component conforming to BS 4254 : 1983. It is where large movement is anticipated in concrete construction and for materials like glass, It has been used in internal and external wall cladding / sealing of joints in water retaining structures such as reservoirs, dams, tanks etc. used for sealing of expansion joints where there vehicular traffic (e.g. airports and bridges) or mixing Resin and Hardener, the polymerization is initiated at room temperature, which proceed further until It has superior joint movement accommodation with strong adhesion to most building material. It is , diesel fuel & kerosene. Smooth paste Off- white 1.60 – 1.75 Refer MSDS Hardner Appearance Colour Specific gravity at 300C, ATM R004 (JIS K6820) Flash Point Mixed Property Mixing ratio R:H (w/w) Colour Specific gravity at 300C, ATM R004 (JIS K6820) Flow , ATM R016 Solid content ,120°C,1hour, % ATM R 010 Curing performance Curing of liquid poly sulphide polymers to high molecular weight elastomers is normally accomplished by oxidizing the polymer’s thiol (-SH) terminals to disulfide ( bonds. Unlike single part two part systems have ability to achieve deep section cure and high ‘green strength’ within few hours Pot life at RT, 500g mix, minutes, ATM R007 Cure time at RT, 500g mix, minutes, ATM R364 The product will achieve its handling strength after hours at room temperature however at least 7 days before full properties are developed Technical Data Sheet Revised on May 2017 Revision no.: 02 , Page 1 of 3 Smooth Paste Brown 1.65 – 1.75 Refer MSDS 92 : 08 Grey 1.60 – 1.70 Non Sag C,1hour, % ≥ 98 ide polymers to high molecular elastomers is normally accomplished by oxidizing SH) terminals to disulfide (-S-S-)